ESPHome on SHA2017 Badge

From NURDspace
Revision as of 18:14, 14 October 2020 by Dennis (talk | contribs)
ESPHome on SHA2017 Badge
NoPicture.png
Participants Dennis
Skills ESP32
Status In progress
Niche Other
Purpose Use for infra
Tool No
Location
Cost
Tool category

ESPHome on SHA2017 Badge Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::{{{Cost}}} | }}

What

The SHA2017 Badge is an awesome piece of hardware based on a ESP32 and an e-ink screen. It can run Micropython and a ton of apps for that are available @ the Hatchery. While I was thinking about writing an app for controlling Home Assistant, I realized that ESPHome would be very suited for that. So here are some pointers to running ESPHome on the SHA2017 Badge.

How to install

I am assuming some familiarity with ESPHome at this point. If not, check the guides on the ESPHome site: https://esphome.io/guides/getting_started_command_line.html or https://esphome.io/guides/getting_started_hassio.html

  • Compile firmware using a yaml config file suited for your needs (a working one can be found here).
  • Upload it to the badge through USB (I used esphome-flasher since I got errors trying uploading with esphome cli and I am too stupid to use esptool :p).

If you enabled wifi and OTA and everything went well, you can program it wirelessly next time.

Stuff that is working

  • Touch pads (through MPR121)
  • USB and battery voltage readings (not verified but they seem sane)
  • Button marked flash on the back

Todo

DKE Group DEPG0290B1 E-Ink screen

Unfortunately the screen is not supported in ESPHome. There is a Waveshare E-Paper Display Component, but it looks like this does not work with our screen. Maybe we can use this as a base for our own component.

RGB(W) LEDs

This proved harder than expected.

  • We need to enable a pin on the MPR121 to power the LEDs, no easy way to do this through MPR121
  • GPIO8 cannot be used because ESPHome build complains this pin is (possibly) being used for the SPI flash

Links