3D printer manual

From NURDspace
Revision as of 20:30, 4 May 2013 by Fwd (talk | contribs) (→‎Print!)
NURDspace Project
link=File:{{{Name}}}.jpg
Participants
Skills
Status
Niche
Purpose
Tool
Location
Cost
Tool category

{{{Name}}}Property "Tool Name" (as page type) with input value "{{{Name}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:{{{Tool}}} | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:{{{Tool}}} | [[Tool Cost::{{{Cost}}} | }}

This manual describes how to use the 3D-printer that's connected to the PrinterPC.

First things first

  • Boot the PrinterPC if it isn't already on, and log in with user 'printer' and password 'printer'.
  • Make sure the printer is on. This is done by switching the PSU on that's next to it.

STL to gcode

  • Open Cura (in the launch menu under 'Other').
  • Load your .STL file with the button 'load model'.
  • Prepare your model with Cura. This will slice your model to coordinates for the 3D-printer.
  • Cura will show the gcode after it's done preparing. With the arrow on top (next to [ 1]) you can cycle through the layers.

Gcode to printer

  • Open Pronterface (also filed under 'Other). This is the printer interface thingy.
  • Click on 'connect' in Pronterface.
  • Preheat the head and bed of the printer. The head must be 185 degrees and the bed 62 degrees. These are probably already set, but if not: type in the degrees in the bottom left corner and click on 'set' (both of them).
  • Check the 'Watch' box and click on 'Check temp'.
  • Wait until the bed and the head are at the desired temperature (you can see them at the bottem of the screen).
  • Load the gcode file that you have made with Cura (not the STL).

Print!

  • Before printing make sure the nozzle is clean. Remove any dripping plastic or crap with tweezers. Don't touch the bed with your fingers: this will make it greasy which prevents the print from sticking to it.
  • Click on 'home' to move the nozzle to the starting position.
  • If the printer is heated click on 'Print'.

Troubleshooting

Questions -> BuZz