FH-1 MIDI controller: Difference between revisions

From NURDspace
(Created page with "{{Project |Name=FH-1 MIDI controller |Skills=Arduino, |Status=In progress |Niche=Music |Purpose=Instrument |Picture=FH-1_MIDI_controller.jpg |Tool=No }} == What == Trying to...")
 
Line 13: Line 13:
* Funduino Arduino Uno R3 clone
* Funduino Arduino Uno R3 clone
* Joystick Shield (marked as V1.A)
* Joystick Shield (marked as V1.A)
* Breakout board with SSD1306 OLED screen
* Breakout board with SSD1306 I2C OLED screen (address 0x3C)
* Toggle switch
* Toggle switch
== Software ==
== Software ==
=== 16U2 firmware ===
=== 16U2 firmware ===

Revision as of 19:15, 12 February 2022

FH-1 MIDI controller
FH-1 MIDI controller.jpg
Participants Dennis
Skills Arduino
Status In progress
Niche Music
Purpose Instrument
Tool No
Location
Cost
Tool category

FH-1 MIDI controller

FH-1_MIDI_controller.jpg {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::{{{Cost}}} | }}

What

Trying to build an Arduino MIDI controller for controlling the Expert Sleepers FH-1 Eurorack module.

Hardware

  • Funduino Arduino Uno R3 clone
  • Joystick Shield (marked as V1.A)
  • Breakout board with SSD1306 I2C OLED screen (address 0x3C)
  • Toggle switch

Software

16U2 firmware

The USB to serial chip on this Funduino board is actually a ATmega16U2 microcontroller. It is possible to reprogram this to act as a USB MIDI -> serial bridge. Details about which firmware I used will follow.

Arduino sketch

In progress...