Dell Equallogic Ps6000 recovery

From NURDspace

Jump to: navigation, search
Dell Equallogic Ps6000 recovery
Participants Rubberduck
Skills Computers
Status Active
Niche Infra
Purpose Education
Tool No
Location @ home
Cost 0
Tool category Infra

Dell Equallogic Ps6000 recovery

/home/arko/Pictures/dell.png {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::0 | }}

1) Console on the Equallogic and powercycle the device

2) Press CTRL+P on boot

3) Use the following commands: EQL> setenv RESETPASSWORD 1 EQL> reload And the defaults are back.

Launch Support Mode > support exec bash To enter a BASH shell > su exec bash

Various “Netstat” and netstat_test commands…some of the most useful networking commands I’ve used so far: netstat -i nstat_test -p 0 nstat_test -r nstat_test -t

“Cache Tool” cachetool

Reveal NetBSD uname -a

“RAIDTOOL” for displaying RAID Info, especially useful in watching the rebuilds with percentages raidtool

Replication Tuning – TCP support repl-window-size

Restart the Equallogic Management Service (Note: You must close and re-launch the Group Manager application after running these commands)

eqlinit restart MgmtExec eqlinit restart-snap MgmtExec support eqlinit “restart MgmtExec”

Check the status od the MgmtExec Service eqlinit status

DOWN and UP ETH Ports … first select the Array that you want to operate on (the example connects to array JERMSMIT-01, then toggles eth0 off and then on again) member select JERMSMIT-01 eth select 0 down eth select 0 up

“UNAME” (unsure what this is actually doing…) uname -a

Restart the Network Management service eqlinit restart-snap netmgtd

“PSGD Test” psgd_test -r

“EQL Logger” eqllogger -r

“Clear Cache” – The clearlostdata command will gather information about the state of this array for support and troubleshooting purposes. clearlostdata

 
Our site is hosted by Site4U
Site4U
Our connectivity is made available by BIT
To BIT's website