Lights: Difference between revisions

From NURDspace
(Created page with "This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: ...")
 
No edit summary
Line 1: Line 1:
= Introduction =
This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace.
This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace.
Original configuration:
Original configuration:
Line 6: Line 7:
The left hand bank of lights
The left hand bank of lights


Current configuration:
= Current configuration =
The left hand switch is for the single emergency light on the left closest to the door.
* The left hand switch is for the single emergency light on the left closest to the door.
The right hand switch does nothing.
* The right hand switch does nothing.
The fluorescent bulbs are connected together into 4 groups:
* The fluorescent bulbs are connected together into 4 groups:
1) The 6 in the dead centre of the space
*# The 6 in the dead centre of the space
2) The 3 over the desks at the far windows
*# The 3 over the desks at the far windows
3) The 2 over the printer desks
*# The 2 over the printer desks
4) The 5 closest to the door, on the near side of the I-beam, excluding the emergency light.
*# The 5 closest to the door, on the near side of the I-beam, excluding the emergency light.


These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.
These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.


DMX
= DMX =
The DMX devices are currently configured as follows:
The DMX devices are currently configured as follows:
Controller: Lanbox currently underneath the Lack by the yellow pipe.
* Controller: Lanbox currently underneath the Lack by the yellow pipe.
Channels 1-4: The small 4x controller on the desks at the far windows
* Channels 1-4: The small 4x controller on the desks at the far windows
Channels 5-8: The strobe lamp
* Channels 5-8: The strobe lamp
Channels 9-12: The main fluorescent bulb controller
* Channels 9-12: The main fluorescent bulb controller


Channels 32-34: The RGB LED lamp (1) on the top of the yellow pipe
* Channels 32-34: The RGB LED lamp (1) on the top of the yellow pipe
Channels 35-37: The RGB LED lamp (2) on the middle of the yellow pipe
* Channels 35-37: The RGB LED lamp (2) on the middle of the yellow pipe
Channels 38-40: The RGB LED lamp (3) on the wall around the corner
* Channels 38-40: The RGB LED lamp (3) on the wall around the corner
Channels 41-43: The RGB LED lamp (4) on the right on the pipes at the far windows
* Channels 41-43: The RGB LED lamp (4) on the right on the pipes at the far windows
Channels 44-46: The RGB LED lamp (5) on the left on the pipes at the far windows
* Channels 44-46: The RGB LED lamp (5) on the left on the pipes at the far windows
Channels 47-49: The RGB LED lamp (6) on the left hand wall.
* Channels 47-49: The RGB LED lamp (6) on the left hand wall.


The DMX cable is wired in the following sequence:
The DMX cable is wired in the following sequence:
Lanbox
* Lanbox
Strobe
* Strobe
RGB1
* RGB1
RGB2
* RGB2
RGB3
* RGB3
(5-->3 conversion)
* (5-->3 conversion)
(3-->5 conversion)
* (3-->5 conversion)
RGB4
* RGB4
(5-->3 conversion)
* (5-->3 conversion)
Small 4x controller
* Small 4x controller
Fluorescent controller
* Fluorescent controller
(3-->5 conversion)
* (3-->5 conversion)
RGB5
* RGB5
RGB6
* RGB6
A 120 ohm resistor is used as termination between pins 2 and 3.
*A 120 ohm resistor is used as termination between pins 2 and 3.

Revision as of 16:14, 2 September 2013

Introduction

This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: The ventilation The right-hand bank of lights (with back to door) including the 3 on the hook around the corner The left hand bank of lights

Current configuration

  • The left hand switch is for the single emergency light on the left closest to the door.
  • The right hand switch does nothing.
  • The fluorescent bulbs are connected together into 4 groups:
    1. The 6 in the dead centre of the space
    2. The 3 over the desks at the far windows
    3. The 2 over the printer desks
    4. The 5 closest to the door, on the near side of the I-beam, excluding the emergency light.

These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.

DMX

The DMX devices are currently configured as follows:

  • Controller: Lanbox currently underneath the Lack by the yellow pipe.
  • Channels 1-4: The small 4x controller on the desks at the far windows
  • Channels 5-8: The strobe lamp
  • Channels 9-12: The main fluorescent bulb controller
  • Channels 32-34: The RGB LED lamp (1) on the top of the yellow pipe
  • Channels 35-37: The RGB LED lamp (2) on the middle of the yellow pipe
  • Channels 38-40: The RGB LED lamp (3) on the wall around the corner
  • Channels 41-43: The RGB LED lamp (4) on the right on the pipes at the far windows
  • Channels 44-46: The RGB LED lamp (5) on the left on the pipes at the far windows
  • Channels 47-49: The RGB LED lamp (6) on the left hand wall.

The DMX cable is wired in the following sequence:

  • Lanbox
  • Strobe
  • RGB1
  • RGB2
  • RGB3
  • (5-->3 conversion)
  • (3-->5 conversion)
  • RGB4
  • (5-->3 conversion)
  • Small 4x controller
  • Fluorescent controller
  • (3-->5 conversion)
  • RGB5
  • RGB6
  • A 120 ohm resistor is used as termination between pins 2 and 3.