Difference between revisions of "Lights"

From NURDspace

Jump to: navigation, search
(DMX: adjust to match reality)
Line 19: Line 19:
  
 
= DMX =
 
= DMX =
The DMX devices are currently configured as follows:
+
The DMX devices are controlled by the [[LanBox]].  DMX channels used:
* Controller: Lanbox currently underneath the Lack by the yellow pipe.
+
* Channels 1-6: node 0
* Channels 1-4: The small 4x controller on the desks at the far windows
+
* Channels 7-12: node 1
* Channels 5-8: The strobe lamp
+
* Channels 13-18: node 2
* Channels 9-12: The main fluorescent bulb controller
+
* Channels 19-24: node 3
 +
* Channels 25-30: node 4
 +
* Channels 31-36: node 5
 +
* Channels 37-42: node 6
 +
* Channels 43-48: node 7
 +
* Channels 49-54: node 8
 +
* Channels 55-60: node 9
 +
* Channels 61-66: node 10
 +
* Channels 67-72: node 11
 +
* Channels 73-78: node 12
 +
* Channels 79-84: node 13
 +
* Channels 85-90: node 14
 +
* Channels 91-96: node 15
 +
* Channel 241: showtec ch 1: fluorescent lights (do not dim!)
 +
* Channel 242: showtec ch 2: defused to prevent gnome attacks
 +
* Channel 243: showtec ch 3: fluorescent lights (do not dim!)
 +
* Channel 244: showtec ch 4: fluorescent lights (do not dim!)
 +
 
 +
{| class="wikitable" style="text-align: center;"
 +
|+ Fluorescent lights schematic
 +
|-
 +
| - - 3 - -
 +
| - - × - -
 +
| - - × - -
 +
| colspan=2 | (kitchen)
 +
|-
 +
| - - 3 - -
 +
| - - 1 - -
 +
| - - 1 - -
 +
| - - × - -
 +
|
 +
| colspan=2 | (living room)
 +
|-
 +
| - - 3 - -
 +
| - - 1 - -
 +
| - - 1 - -
 +
| - - 1 - -
 +
|
 +
| - - 4 - -
 +
| - - 4 - -
 +
|}
  
* Channels 32-34: The RGB LED lamp (1) on the top of the yellow pipe
 
* Channels 35-37: The RGB LED lamp (2) on the middle of the yellow pipe
 
* Channels 38-40: The RGB LED lamp (3) on the wall around the corner
 
* Channels 41-43: The RGB LED lamp (4) on the right on the pipes at the far windows
 
* Channels 44-46: The RGB LED lamp (5) on the left on the pipes at the far windows
 
* Channels 47-49: The RGB LED lamp (6) on the left hand wall.
 
  
 
The DMX cable is wired in the following sequence:
 
The DMX cable is wired in the following sequence:
 
* Lanbox
 
* Lanbox
* Strobe
 
* RGB1
 
* RGB2
 
* RGB3
 
* (5-->3 conversion)
 
* (3-->5 conversion)
 
* RGB4
 
 
* (5-->3 conversion)
 
* (5-->3 conversion)
* Small 4x controller
+
* [http://www.liquidx.nl/media/downloads/licht/Showtec%20MultiDim%20MKII%204-kan-5A%2050386.pdf ShowTec MultiDim MKII]
* Fluorescent controller
+
* a swarm of nodes
* (3-->5 conversion)
+
* any termination? maybe? anyone?
* RGB5
+
* RGB6
+
*A 120 ohm resistor is used as termination between pins 2 and 3.
+
  
 
= Commands =
 
= Commands =

Revision as of 15:41, 18 June 2016

Introduction

This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: The ventilation The right-hand bank of lights (with back to door) including the 3 on the hook around the corner The left hand bank of lights

Current configuration

  • The left hand switch is for the single emergency light on the left closest to the door.
  • The right hand switch does nothing.
  • The fluorescent bulbs are connected together into 4 numbered groups:
    1. The 6 in the dead centre of the space
    2. The 2 over the printer desks (currently disabled)
    3. The 3 over the desks at the far windows
    4. The 5 closest to the door, on the near side of the I-beam, excluding the emergency light (only 2 of them are currently working).

These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.

DMX

The DMX devices are controlled by the LanBox. DMX channels used:

  • Channels 1-6: node 0
  • Channels 7-12: node 1
  • Channels 13-18: node 2
  • Channels 19-24: node 3
  • Channels 25-30: node 4
  • Channels 31-36: node 5
  • Channels 37-42: node 6
  • Channels 43-48: node 7
  • Channels 49-54: node 8
  • Channels 55-60: node 9
  • Channels 61-66: node 10
  • Channels 67-72: node 11
  • Channels 73-78: node 12
  • Channels 79-84: node 13
  • Channels 85-90: node 14
  • Channels 91-96: node 15
  • Channel 241: showtec ch 1: fluorescent lights (do not dim!)
  • Channel 242: showtec ch 2: defused to prevent gnome attacks
  • Channel 243: showtec ch 3: fluorescent lights (do not dim!)
  • Channel 244: showtec ch 4: fluorescent lights (do not dim!)
Fluorescent lights schematic
- - 3 - - - - × - - - - × - - (kitchen)
- - 3 - - - - 1 - - - - 1 - - - - × - - (living room)
- - 3 - - - - 1 - - - - 1 - - - - 1 - - - - 4 - - - - 4 - -


The DMX cable is wired in the following sequence:

Commands

The lights can be operated on #nurds using the following commands:

  •  !ziza - Turn off TL tubes.
  •  !aziz - Turn on TL tubes.
 
Our site is hosted by Site4U
Site4U
Our connectivity is made available by BIT
To BIT's website