Minibeamer: Difference between revisions

From NURDspace
No edit summary
Line 11: Line 11:


= Info gathering =
= Info gathering =
* Some example project by someone else; [http://jderogee.tripod.com/projects/beamer/4Kpixel_beamer.html is here]
* Information on the display: [http://serdisplib.sourceforge.net/ser/pcd8544.html serdisplib]
* Information on the display: [http://serdisplib.sourceforge.net/ser/pcd8544.html serdisplib]
The one I've got is a 'type 2'.
The one I've got is a 'type 2'.

Revision as of 16:16, 30 October 2012

NURDspace Project
link=File:{{{Name}}}.jpg
Participants Dennis
Skills
Status
Niche
Purpose
Tool
Location
Cost
Tool category

{{{Name}}}Property "Tool Name" (as page type) with input value "{{{Name}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:{{{Tool}}} | [[Tool Owner::User:The_Niz | }} {{#if:{{{Tool}}} | [[Tool Cost::{{{Cost}}} | }}

Introduction

With some lenses, an old LCD from a mobile phone, a bright LED and some driving electronics it should be viable to build a device capable of projecting stuff on your wall. Note: The dutch pseudo-anglicism "beamer" means video projector.

Info gathering

The one I've got is a 'type 2'.

Cabling

I could'n find a male DB25 connector so I checked whether a cable I had lying around would be useful.

Male-male DB25 (LapLink Cable?)

PCPARPORT OTHEREND
PIN2=D0 PIN15
PIN3=D1 PIN13
PIN4=D2 PIN12
PIN7=D5 NC
PIN9=D7 NC

Since PIN7 is not connected this isn't going to work :(

Parallel floppy cable

Next candidate was a short cable normally used to connect the floppy drive of an Olivetti Echos Pentium 1 laptop. Again: some pins that I needed weren't connected.

Parallel printer cable

This one looks promising according to http://www.lammertbies.nl/comm/cable/parallel.html I don't own the connector that fits the 36 pins Centronics connector so I'll cut up the cable and connect the wires directly to the resistors.