Pokons to do list

From NURDspace
Revision as of 16:56, 5 August 2018 by Pokon (talk | contribs) (Created page with "{{Project |Name=Pokons printer to do list |Status=Planning |Niche=Documentation |Purpose=Infra |Tool=Yes |Location=everywhere where there is a printer |Cost=dont know dont car...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Pokons printer to do list
NoPicture.png
Participants
Skills
Status Planning
Niche Documentation
Purpose Infra
Tool Yes
Location everywhere where there is a printer
Cost dont know dont care
Tool category Electronics

Pokons printer to do list Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}

Anet a8 stock -Resolder wires from the board to the mosfet -PID tune so it wont overshoot about 50 degrees -check filament gear because of grinding -Level the bed once again

Malyan m200 Modded -write the marlin config -level the bed -PID tune -get a glass bed and relevel again

Super metal space printer (aka anet but with extrusions) -wire the electronics -get a mosfet for the bed -PID tune -Level the bed -testprint -make a cura profile -hook it up to octoprint -make a manual so that every nurd can use it

Envisiontec printer -poke envisiontec again -poke around in the community for an opensource alternative