Pokons to do list

From NURDspace
Revision as of 17:07, 5 August 2018 by Buzz (talk | contribs)
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Pokons printer to do list
NoPicture.png
Participants
Skills
Status Planning
Niche Documentation
Purpose Infra
Tool Yes
Location everywhere where there is a printer
Cost dont know dont care
Tool category Electronics

Pokons printer to do list Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}

Anet a8 stock

  • Resolder wires from the board to the mosfet
  • PID tune so it wont overshoot about 50 degrees
  • check filament gear because of grinding
  • Level the bed once again

Malyan m200 Modded

  • write the marlin config
  • level the bed
  • PID tune
  • get a glass bed and relevel again

Super metal space printer (aka anet but with extrusions)

  • wire the electronics
  • get a mosfet for the bed
  • PID tune
  • Level the bed
  • testprint
  • make a cura profile
  • hook it up to octoprint
  • make a manual so that every nurd can use it

Envisiontec printer

  • poke envisiontec again
  • give buzz the backup finally so he can get the software hacked
  • poke around in the community for an opensource alternative