Difference between revisions of "Space anet a8"

From NURDspace

Jump to: navigation, search
m
Line 27: Line 27:
  
 
printed upgrades (links will be added):
 
printed upgrades (links will be added):
* Bulleted list item
+
*x tensioner  
*x tensioner
+
*https://www.thingiverse.com/thing:1492411
 
*y tensioner
 
*y tensioner
 +
*same as the x one 2 files in one :)
 
*frame thing stabalizer  
 
*frame thing stabalizer  
*fan duct (best not to print in pla because of melty)
+
*https://www.thingiverse.com/thing:1672959
 +
*fan duct (best not to print in pla because of meltyness)
 +
*https://www.thingiverse.com/thing:2133328
  
 
The printer will be eventually be fully upgraded to a AM8
 
The printer will be eventually be fully upgraded to a AM8
 
*https://www.thingiverse.com/thing:2263216
 
*https://www.thingiverse.com/thing:2263216
 +
 +
To do list:
 +
*build manual so other people can print with
 +
*place the links for the 3d printed upgrades
 +
*upgrade the printer to said AM8 frame

Revision as of 16:57, 21 August 2017

Anet a8 for space
NoPicture.png
Participants Pokon
Skills pokoning, 3D Printing, screaming
Status Active
Niche Printing
Purpose Electronics, fun, world domination
Tool No
Location with the rest of the printers
Cost 120 ish
Tool category Electronics

Anet a8 for space

"File:{{{Picture}}}" cannot be used as a page name in this wiki.

{{{Picture}}} {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::120 ish | }}

So another day another 3d printer

this time its the anet a8 from el cheapo land gearbest

below you will find the profile settings for cura 2.6.2

upgrades wich are needed:

  • New PSU (the one that came with is a fire hazard)
  • Mosfet (board of the printer cant handle the amps directly)

https://www.aliexpress.com/item/3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board/32765683570.html?spm=a2g0s.9042311.0.0.b522U7

  • putting spades on the cables from the psu and heatbed
  • replace heatbed wire for thicker ones (the cables from a eurostekker are suffecient)
  • solder the wires directly on the headbed (connector is a fun fire hazard)


printed upgrades (links will be added):

The printer will be eventually be fully upgraded to a AM8

To do list:

  • build manual so other people can print with
  • place the links for the 3d printed upgrades
  • upgrade the printer to said AM8 frame
 
Our site is hosted by Site4U
Site4U
Our connectivity is made available by BIT
To BIT's website