Lights

From NURDspace
Revision as of 00:36, 2 September 2013 by Talloak (talk | contribs) (Created page with "This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: ...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: The ventilation The right-hand bank of lights (with back to door) including the 3 on the hook around the corner The left hand bank of lights

Current configuration: The left hand switch is for the single emergency light on the left closest to the door. The right hand switch does nothing. The fluorescent bulbs are connected together into 4 groups: 1) The 6 in the dead centre of the space 2) The 3 over the desks at the far windows 3) The 2 over the printer desks 4) The 5 closest to the door, on the near side of the I-beam, excluding the emergency light.

These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.

DMX The DMX devices are currently configured as follows: Controller: Lanbox currently underneath the Lack by the yellow pipe. Channels 1-4: The small 4x controller on the desks at the far windows Channels 5-8: The strobe lamp Channels 9-12: The main fluorescent bulb controller

Channels 32-34: The RGB LED lamp (1) on the top of the yellow pipe Channels 35-37: The RGB LED lamp (2) on the middle of the yellow pipe Channels 38-40: The RGB LED lamp (3) on the wall around the corner Channels 41-43: The RGB LED lamp (4) on the right on the pipes at the far windows Channels 44-46: The RGB LED lamp (5) on the left on the pipes at the far windows Channels 47-49: The RGB LED lamp (6) on the left hand wall.

The DMX cable is wired in the following sequence: Lanbox Strobe RGB1 RGB2 RGB3 (5-->3 conversion) (3-->5 conversion) RGB4 (5-->3 conversion) Small 4x controller Fluorescent controller (3-->5 conversion) RGB5 RGB6 A 120 ohm resistor is used as termination between pins 2 and 3.