| Line 17: | Line 17: | ||
== Software == | == Software == | ||
=== 16U2 firmware === | === dualMocoLUFA 16U2 firmware === | ||
The USB to serial chip on this Funduino board is actually a ATmega16U2 microcontroller. It is possible to reprogram this to act as a USB MIDI -> serial bridge. | The USB to serial chip on this Funduino board is actually a ATmega16U2 microcontroller. It is possible to reprogram this to act as a USB MIDI -> serial bridge. I used [http://morecatlab.akiba.coocan.jp/lab/index.php/aruino/midi-firmware-for-arduino-uno-moco/?lang=en dualMocoLUFA] and soldered on a toggle switch to switch between MIDI mode and normal mode (to upload new sketches). | ||
=== Arduino sketch === | === Arduino sketch === | ||
In progress... | In progress... | ||
Revision as of 11:09, 14 February 2022
| FH-1 MIDI controller | |
|---|---|
 | |
| Participants | Dennis |
| Skills | Arduino |
| Status | In progress |
| Niche | Music |
| Purpose | Instrument |
| Tool | No |
| Location | |
| Cost | |
| Tool category | |
FH-1_MIDI_controller.jpg {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::{{{Cost}}} | }}
What
Trying to build an Arduino MIDI controller for controlling the Expert Sleepers FH-1 Eurorack module.
Hardware
- Funduino Arduino Uno R3 clone
- Joystick Shield (marked as V1.A)
- Breakout board with SSD1306 I2C OLED screen (address 0x3C)
- Toggle switch
Software
dualMocoLUFA 16U2 firmware
The USB to serial chip on this Funduino board is actually a ATmega16U2 microcontroller. It is possible to reprogram this to act as a USB MIDI -> serial bridge. I used dualMocoLUFA and soldered on a toggle switch to switch between MIDI mode and normal mode (to upload new sketches).
Arduino sketch
In progress...