3D-Print Farm: Difference between revisions
Jump to navigation
Jump to search
(Created page with "{{Project |Name=3D-Print Farm |Status=Operational |Niche=3D Printing |Purpose=Reliable fabrication |Picture=3d-Print Farm.jpeg |Tool=Yes |Location=3D-Corner |Category=Fabrication }} Printserver is available at http://10.208.1.19/ or http://http://nurds3d.lan.nurd.space/. We try to keep an array of working printers connected to this server. Current printers: * Ultimaker Original (3mm) * Ultimaker Original + (3mm) * Creality Ender-3 V2 (1.75mm) Limitations: *...") |
(No difference)
|
Revision as of 22:50, 28 August 2024
| 3D-Print Farm | |
|---|---|
| Participants | |
| Skills | |
| Status | Operational |
| Niche | 3D Printing |
| Purpose | Reliable fabrication |
| Tool | Yes |
| Location | 3D-Corner |
| Cost | |
| Tool category | Fabrication |
3d-Print Farm.jpeg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::{{{Cost}}} | }}
Printserver is available at http://10.208.1.19/ or http://http://nurds3d.lan.nurd.space/.
We try to keep an array of working printers connected to this server.
Current printers:
- Ultimaker Original (3mm)
- Ultimaker Original + (3mm)
- Creality Ender-3 V2 (1.75mm)
Limitations:
- Ultimaker Original (+) are prone to heat-creep with the combination of higher temperature filaments, frequent retractions/low-flow conditions.
Upgrade plans:
- Replace hotend in Ultimaker Original (+) with E3DV6
- Replace Ultimaker extruders with E3D
We recommend using PrusaSlic3r. Printer profiles to follow ...