3D-Print Farm: Difference between revisions

From NURDspace
Jump to navigation Jump to search
(Created page with "{{Project |Name=3D-Print Farm |Status=Operational |Niche=3D Printing |Purpose=Reliable fabrication |Picture=3d-Print Farm.jpeg |Tool=Yes |Location=3D-Corner |Category=Fabrication }} Printserver is available at http://10.208.1.19/ or http://http://nurds3d.lan.nurd.space/. We try to keep an array of working printers connected to this server. Current printers: * Ultimaker Original (3mm) * Ultimaker Original + (3mm) * Creality Ender-3 V2 (1.75mm) Limitations: *...")
 
No edit summary
 
(11 intermediate revisions by 2 users not shown)
Line 9: Line 9:
|Category=Fabrication
|Category=Fabrication
}}
}}
Printserver is available at http://10.208.1.19/ or http://http://nurds3d.lan.nurd.space/.


We try to keep an array of working printers connected to this server.
We try to keep an array of working printers connected to this server.


Current printers:
Current working printers:
* Ultimaker Original (3mm)
* Ultimaker Original modified Direct Drive(1.75mm)
* Ultimaker Original + (3mm)
* Creality Ender-3 V2 (1.75mm)


Limitations:
You can get the Prusaslicer config here:
* Ultimaker Original (+) are prone to heat-creep with the combination of higher temperature filaments, frequent retractions/low-flow conditions.
[https://cloud.nurd.space/f/1300185 UMO+DD_Prusaslicer_config.ini]


Upgrade plans:
Upload your gcode via network or USB disk.
* Replace hotend in Ultimaker Original (+) with E3DV6
 
* Replace Ultimaker extruders with E3D
Some suggestions:
We recommend using PrusaSlic3r. Printer profiles to follow ...
* please don't use old (and thus brittle) filament
* use hairspray on the buildplate as needed
* check leveling of buildplate for proper adhesion
* remove filament immediately after printing to avoid breakage of filament in the extruder
 
 
 
For support/assistance contact berend.

Latest revision as of 00:41, 23 April 2026

3D-Print Farm
3d-Print Farm.jpeg
Participants
Skills
Status Operational
Niche 3D Printing
Purpose Reliable fabrication
Tool Yes
Location 3D-Corner
Cost
Tool category Fabrication

3D-Print Farm

3d-Print Farm.jpeg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::{{{Cost}}} | }}


We try to keep an array of working printers connected to this server.

Current working printers:

  • Ultimaker Original modified Direct Drive(1.75mm)

You can get the Prusaslicer config here: UMO+DD_Prusaslicer_config.ini

Upload your gcode via network or USB disk.

Some suggestions:

  • please don't use old (and thus brittle) filament
  • use hairspray on the buildplate as needed
  • check leveling of buildplate for proper adhesion
  • remove filament immediately after printing to avoid breakage of filament in the extruder


For support/assistance contact berend.