3D-Print Farm: Difference between revisions

From NURDspace
Jump to navigation Jump to search
mNo edit summary
No edit summary
 
(9 intermediate revisions by 2 users not shown)
Line 9: Line 9:
|Category=Fabrication
|Category=Fabrication
}}
}}
Printserver is available at http://10.208.1.19/ or http://http://nurds3d.lan.nurd.space/.


We try to keep an array of working printers connected to this server.
We try to keep an array of working printers connected to this server.


Current printers:
Current working printers:
* Ultimaker Original (3mm)
* Ultimaker Original modified Direct Drive(1.75mm)
* Ultimaker Original + (3mm)
* Creality Ender-3 V2 (1.75mm)


Limitations:
You can get the Prusaslicer config here:
* Ultimaker Original (+) are prone to heat-creep with the combination of higher temperature filaments, frequent retractions/low-flow conditions.
[https://cloud.nurd.space/f/1300185 UMO+DD_Prusaslicer_config.ini]


Upgrade plans:
Upload your gcode via network or USB disk.
* Replace hotend in Ultimaker Original (+) with E3DV6
* Replace Ultimaker extruders with E3D


'''IMPORTANT NOTE: both Ultimakers have custom firmware because pins were not working and a pinswap in the firmware was necessary.'''
Some suggestions:
* Ultimaker Original: Y-axis (IIRC) step and dir swapped to spare driver position.
* please don't use old (and thus brittle) filament
* Ultimaker Original +: cooling fan was not working properly. swapped with pwm-output of LEDs. Hopefully fixed soon by replacing transistor.
* use hairspray on the buildplate as needed
* check leveling of buildplate for proper adhesion
* remove filament immediately after printing to avoid breakage of filament in the extruder


 


We recommend using PrusaSlic3r to convert STL to gcode, then upload gcode to the appropriate printer on the server and print. Printer profiles to follow ...
For support/assistance contact berend.

Latest revision as of 00:41, 23 April 2026

3D-Print Farm
3d-Print Farm.jpeg
Participants
Skills
Status Operational
Niche 3D Printing
Purpose Reliable fabrication
Tool Yes
Location 3D-Corner
Cost
Tool category Fabrication

3D-Print Farm

3d-Print Farm.jpeg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::{{{Cost}}} | }}


We try to keep an array of working printers connected to this server.

Current working printers:

  • Ultimaker Original modified Direct Drive(1.75mm)

You can get the Prusaslicer config here: UMO+DD_Prusaslicer_config.ini

Upload your gcode via network or USB disk.

Some suggestions:

  • please don't use old (and thus brittle) filament
  • use hairspray on the buildplate as needed
  • check leveling of buildplate for proper adhesion
  • remove filament immediately after printing to avoid breakage of filament in the extruder


For support/assistance contact berend.