3D-Print Farm: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 9: | Line 9: | ||
|Category=Fabrication | |Category=Fabrication | ||
}} | }} | ||
We try to keep an array of working printers connected to this server. | We try to keep an array of working printers connected to this server. | ||
Current printers: | Current working printers: | ||
* Ultimaker Original | * Ultimaker Original modified Direct Drive(1.75mm) | ||
You can get the Prusaslicer config here: | |||
[https://cloud.nurd.space/f/1300185 UMO+DD_Prusaslicer_config.ini] | |||
Upload your gcode via network or USB disk. | |||
' | Some suggestions: | ||
* | * please don't use old (and thus brittle) filament | ||
* | * use hairspray on the buildplate as needed | ||
* check leveling of buildplate for proper adhesion | |||
* remove filament immediately after printing to avoid breakage of filament in the extruder | |||
For support/assistance contact berend. | |||
Latest revision as of 00:41, 23 April 2026
| 3D-Print Farm | |
|---|---|
| Participants | |
| Skills | |
| Status | Operational |
| Niche | 3D Printing |
| Purpose | Reliable fabrication |
| Tool | Yes |
| Location | 3D-Corner |
| Cost | |
| Tool category | Fabrication |
3d-Print Farm.jpeg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::{{{Cost}}} | }}
We try to keep an array of working printers connected to this server.
Current working printers:
- Ultimaker Original modified Direct Drive(1.75mm)
You can get the Prusaslicer config here: UMO+DD_Prusaslicer_config.ini
Upload your gcode via network or USB disk.
Some suggestions:
- please don't use old (and thus brittle) filament
- use hairspray on the buildplate as needed
- check leveling of buildplate for proper adhesion
- remove filament immediately after printing to avoid breakage of filament in the extruder
For support/assistance contact berend.