| Line 17: | Line 17: | ||
* The state of the machine is unknown it could just work | * The state of the machine is unknown it could just work | ||
* Since owner of our building objected to the use of this machine, we had to pass on it. :( | * Since owner of our building objected to the use of this machine, we had to pass on it. :( | ||
* The machine is now at Fablab Amersfoort/De Spullenmannen/De War - fablabamersfoort.nl | * The machine is now at Fablab Amersfoort/De Spullenmannen/De War - http://fablabamersfoort.nl | ||
== Machine info == | == Machine info == | ||
Revision as of 10:39, 30 June 2015
| CNC Machine | |
|---|---|
 | |
| Participants | |
| Skills | |
| Status | Planning |
| Niche | Hardware |
| Purpose | Infrastructure |
| Tool | Yes |
| Location | |
| Cost | |
| Tool category | |
photo417640197957724076.jpg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost:: | }}
Current status
- Machine was at ROC A12 in Ede.
- Machine could have been delivered to us for E150,- in june 2015.
- The state of the machine is unknown it could just work
- Since owner of our building objected to the use of this machine, we had to pass on it. :(
- The machine is now at Fablab Amersfoort/De Spullenmannen/De War - http://fablabamersfoort.nl
Machine info
- File:CNC manual.pdf
- According to the provided manual these are the specs: http://www.mapemachines.com/main.asp?scb=cnc2l
- It works on 230 Volt, 1 phase and i think it needs about 10 Amp
- The machines weight is around 1250KG
- Width=85cm, Length=100cm, Height=155cm
- Pick and Place, vacuum
- Soldering (accuracy 0,01 mm)
- Drilling (accuracy 0,015 mm)
- Milling
