Minibeamer

NURDspace Project
Participants	Dennis
Skills
Status
Niche
Purpose
Tool
Location
Cost
Tool category

{{{Name}}}Property "Tool Name" (as page type) with input value "{{{Name}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:{{{Tool}}} | [[Tool Owner::User:The_Niz | }} {{#if:{{{Tool}}} | [[Tool Cost::{{{Cost}}} | }}

Introduction

With some lenses, an old LCD from a mobile phone, a bright LED and some driving electronics it should be viable to build a device capable of projecting stuff on your wall. Note: The dutch pseudo-anglicism "beamer" means video projector.

Info gathering

• Information on the display: serdisplib

The one I've got is a 'type 2'.

Cabling

Male-male DB25 (LapLink Cable?)

I could'n find a male DB25 connector so I checked whether a cable I had lying around would be useful.

PCPARPORT	OTHEREND
PIN2=D0	PIN15
PIN3=D1	PIN13
PIN4=D2	PIN12
PIN7=D5	NC
PIN9=D7	NC

• PCPARPORT = parallel port found on standard pc, http://edge.kitiyo.com/2009/pc-interface-logic/parallel-pc-interface-unit.html
• OTHEREND = other end of cable (standard LapLink??? http://en.wikipedia.org/wiki/LapLink_cable)

Since PIN7 is not connected this isn't going to work :(