| ITT Metrix OX-800 Oscilloscope | |
|---|---|
 | |
| Owner | Zarya |
| Status | Working |
| Location | Soldering Table |
| Tool | Yes |
| Tool category | Electronics |
ITT Metrix OX-800 Oscilloscope
2014-01-09 23.20.23.jpg {{{InventoryOwner}}}Property "Tool Owner" (as page type) with input value "{{{InventoryOwner}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. Soldering Table
Specs
- 2 Channels
- 20 Mhz
Documentation
French only, I have not been able to find any documentation in English.
User Manuel (French)
File:Metrix OX800 Notice de Fonctionnement.pdf
Service manual with schematics (french)
File:METRIX_OX800_Oscilloscope_-_Manuel_de_maintenance.pdf
Schematics (French - higher resolution, alternative source)
File:esquemas-de-osciloscopio-metrix-ox800.pdf
How to use this
- if you have never used a scoop check out this page http://afrotechmods.com/tutorials/2011/11/27/oscilloscope-tutorials/
- Sometimes it doesn't startup right. You can try restarting it or give it a good whack. (seems fixed now)
Probes
Probes can be found hanging on the cable rack thingie in zaal 2.
Troubleshooting
Z1501 and Z1502 regulators are getting extremely hot. possibly power supply rail problem somewhere.