| OpenRC F1 car | |
|---|---|
 | |
| Participants | |
| Skills | 3D Printing, Assembling, Electronics |
| Status | Finished |
| Niche | Electronics |
| Purpose | Electronics, fun, world domination |
| Tool | No |
| Location | mounted on the kitchen wall |
| Cost | money euros and stuff |
| Tool category | |
OpenRC-20180127.jpg {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::money euros and stuff | }}
I wanted to get more info on RC stuff because why not, also i wanted to print this project a long time.
Pokon trying the openRC project
Its an Formula 1 based RC car which is open-source made by Daniel Noree
Driving a bit with FPV and taking it to Sweden for the 3Dprint meet-up with the maker of the project (you know show and tell)
SOOOO LETS GET STARTED
the bill of materials is provided on the thingiverse page, if you don't want to look it up check the sheet down below
Here are some pictures of the assembly, the assembly instructions will be down below the pictures.