3D-Print Farm

From NURDspace
Revision as of 00:41, 23 April 2026 by Berend (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
3D-Print Farm
3d-Print Farm.jpeg
Participants
Skills
Status Operational
Niche 3D Printing
Purpose Reliable fabrication
Tool Yes
Location 3D-Corner
Cost
Tool category Fabrication

3D-Print Farm

3d-Print Farm.jpeg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::{{{Cost}}} | }}


We try to keep an array of working printers connected to this server.

Current working printers:

  • Ultimaker Original modified Direct Drive(1.75mm)

You can get the Prusaslicer config here: UMO+DD_Prusaslicer_config.ini

Upload your gcode via network or USB disk.

Some suggestions:

  • please don't use old (and thus brittle) filament
  • use hairspray on the buildplate as needed
  • check leveling of buildplate for proper adhesion
  • remove filament immediately after printing to avoid breakage of filament in the extruder


For support/assistance contact berend.