Introduction
This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: The ventilation The right-hand bank of lights (with back to door) including the 3 on the hook around the corner The left hand bank of lights
Current configuration
- The left hand switch is for the single emergency light on the left closest to the door.
- The right hand switch does nothing.
- The fluorescent bulbs are connected together into 4 numbered groups:
- The 6 in the dead centre of the space
- The 2 over the printer desks (currently disabled)
- The 3 over the desks at the far windows
- The 5 closest to the door, on the near side of the I-beam, excluding the emergency light (only 2 of them are currently working).
These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.
DMX
The DMX devices are controlled by the LanBox. DMX channels used:
- Channels 1-6: node 0
- Channels 7-12: node 1
- Channels 13-18: node 2
- Channels 19-24: node 3
- Channels 25-30: node 4
- Channels 31-36: node 5
- Channels 37-42: node 6
- Channels 43-48: node 7
- Channels 49-54: node 8
- Channels 55-60: node 9
- Channels 61-66: node 10
- Channels 67-72: node 11
- Channels 73-78: node 12
- Channels 79-84: node 13
- Channels 85-90: node 14
- Channels 91-96: node 15
- Channel 241: showtec ch 1: fluorescent lights (do not dim!)
- Channel 242: showtec ch 2: defused to prevent gnome attacks
- Channel 243: showtec ch 3: fluorescent lights (do not dim!)
- Channel 244: showtec ch 4: fluorescent lights (do not dim!)
| - - 3 - - | - - 2 - - | - - 2 - - | (kitchen) | |||
| - - 3 - - | - - 1 - - | - - 1 - - | - - × - - | (living room) | ||
| - - 3 - - | - - 1 - - | - - 1 - - | - - 1 - - | - - 4 - - | - - 4 - - | |
The DMX cable is wired in the following sequence:
- Lanbox
- (5-->3 conversion)
- ShowTec MultiDim MKII
- a swarm of nodes
- any termination? maybe? anyone?
Commands
The lights can be operated on #nurds using the following commands:
- !ziza - Turn off TL tubes.
- !aziz - Turn on TL tubes.