| Turnigy Mini Fabrikator II | |
|---|---|
 | |
| Participants | |
| Skills | knowledge sharing, link gathering |
| Status | Production |
| Niche | Printing |
| Purpose | Tool |
| Tool | No |
| Location | |
| Cost | |
| Tool category | |
Minifabv2.jpg {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::{{{Cost}}} | }}
This printer is made by Malyan as the M100 model. Not many shops sell it, but hobbyking sells them rebranded :
Some configs and tools
- http://space.nurdspace.nl/~buzz/cura1504-minifabv2-profiles.tgz
- http://space.nurdspace.nl/~buzz/cura_15.04.7-RC5-debian_amd64.deb
Updated profile 2020
This profile is set to 100% fill and 2 perimeter walls, just variate on that for lesser filled objects. (for example; 4 perimeters and 0% fill work nice for many sculptures)
Replacement parts
My X belt snapped so i just ordered two new closed loops. I was hoping to use a open ended belt, but seems not fitting.
Both the X and Y belt are B150MXL aka 1200MXL , ~5mm wide so 1200MXL-019.
Many of the parts for a Malyan M200 (aka Monoprice Mini Select (v1/2/3)) are compatible.
Nanopi stuffed inside
Finally stuffed the nanopi that i run octoprint on inside the frame:
