3D-Print Farm
Jump to navigation
Jump to search
| 3D-Print Farm | |
|---|---|
| Participants | |
| Skills | |
| Status | Operational |
| Niche | 3D Printing |
| Purpose | Reliable fabrication |
| Tool | Yes |
| Location | 3D-Corner |
| Cost | |
| Tool category | Fabrication |
3d-Print Farm.jpeg {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::{{{Cost}}} | }}
We try to keep an array of working printers connected to this server.
Current working printers:
- Ultimaker Original modified Direct Drive(1.75mm)
You can get the Prusaslicer config here: UMO+DD_Prusaslicer_config.ini
Upload your gcode via network or USB disk.
Some suggestions:
- please don't use old (and thus brittle) filament
- use hairspray on the buildplate as needed
- check leveling of buildplate for proper adhesion
- remove filament immediately after printing to avoid breakage of filament in the extruder
For support/assistance contact berend.