Introduction

This is a beginning entry dedicated to the light setup in Diedenoort-NURDSpace. Original configuration: The three wall switches by the front door operate, from left to right: The ventilation The right-hand bank of lights (with back to door) including the 3 on the hook around the corner The left hand bank of lights

Current configuration

The left hand switch is for the single emergency light on the left closest to the door.
The right hand switch does nothing.
The fluorescent bulbs are connected together into 4 numbered groups:
1. The 6 in the dead centre of the space
2. The 2 over the printer desks (currently disabled)
3. The 3 over the desks at the far windows
4. The 5 closest to the door, on the near side of the I-beam, excluding the emergency light (only 2 of them are currently working).

These 4 channels are plugged into the lighting controller suspended in a white iron grid from the ceiling. This is plugged into a ceiling socket on a ? electrical group.

DMX

The DMX devices are currently configured as follows:

Controller: Lanbox currently underneath the Lack by the yellow pipe.
Channels 1-4: The small 4x controller on the desks at the far windows
Channels 5-8: The strobe lamp
Channels 9-12: The main fluorescent bulb controller

Channels 32-34: The RGB LED lamp (1) on the top of the yellow pipe
Channels 35-37: The RGB LED lamp (2) on the middle of the yellow pipe
Channels 38-40: The RGB LED lamp (3) on the wall around the corner
Channels 41-43: The RGB LED lamp (4) on the right on the pipes at the far windows
Channels 44-46: The RGB LED lamp (5) on the left on the pipes at the far windows
Channels 47-49: The RGB LED lamp (6) on the left hand wall.

The DMX cable is wired in the following sequence:

Lanbox
Strobe
RGB1
RGB2
RGB3
(5-->3 conversion)
(3-->5 conversion)
RGB4
(5-->3 conversion)
Small 4x controller
Fluorescent controller
(3-->5 conversion)
RGB5
RGB6
A 120 ohm resistor is used as termination between pins 2 and 3.