ESPHome on SHA2017 Badge

From NURDspace
ESPHome on SHA2017 Badge
SHABadgeESPHome1.jpg
Participants Dennis
Skills ESP32
Status In progress
Niche Other
Purpose Use for infra
Tool No
Location
Cost
Tool category

ESPHome on SHA2017 Badge

SHABadgeESPHome1.jpg {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::{{{Cost}}} | }}

What

The SHA2017 Badge is an awesome piece of hardware based on a ESP32 and an e-ink screen. It can run Micropython and a ton of apps for that are available @ the Hatchery. While I was thinking about writing an app for controlling Home Assistant, I realized that ESPHome would be very suited for that. So here are some pointers to running ESPHome on the SHA2017 Badge.

How to install

I am assuming some familiarity with ESPHome at this point. If not, check the guides on the ESPHome site: https://esphome.io/guides/getting_started_command_line.html or https://esphome.io/guides/getting_started_hassio.html

  • Create a yaml config file suited for your needs (a working base can be found here).
  • Run
    esphome run yourconfig.yaml

It shoud compile and upload your firmware to the badge over USB. If you enabled wifi and OTA and everything went well, you can program it wirelessly next time.

Stuff that is working

  • Touch pads (through MPR121)
  • USB and battery voltage readings (not verified but they seem sane)
  • Button marked flash on the back
  • DKE Group DEPG0290B1 E-Ink screen (Full refresh only for now, uses this quick and dirty driver modification. I updated the gist with config for it.)

Todo

DKE Group DEPG0290B1 E-Ink screen

I started modifying Waveshare E-Paper Display Component, it can do full refresh now. I would like to also implement partial refresh and make a pull request for ESPHome.

RGB(W) LEDs

This proved harder than expected.

  • We need to enable a pin on the MPR121 to power the LEDs, no easy way to do this through MPR121. This component is only for the touch sensing, not the GPIO expander stuff.

Links