Karretje: Difference between revisions

From NURDspace
No edit summary
No edit summary
Line 48: Line 48:
What is left is a compass and lots of hot-glue. Software is also almost finished. Oh and I've added a powerbutton that power-downs safely the rpi when the button is a pressed for a bit.
What is left is a compass and lots of hot-glue. Software is also almost finished. Oh and I've added a powerbutton that power-downs safely the rpi when the button is a pressed for a bit.


[[File:Progress1.jpg]]
[[File:Progress1.jpg|800px]]


^ tiewraps and glue!
^ tiewraps and glue!

Revision as of 14:58, 29 March 2022

Karretje
Base.jpg
Participants Folkert
Skills Electronics, Programming
Status Active
Niche Geinig
Purpose Fun
Tool No
Location Thuis
Cost Infinite
Tool category Electronics

Karretje

Base.jpg {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::Infinite | }}


Karretje will become a autonomously driving raspberry pi based vehicle.

It really is karretjeng as before there was this one:

Karretje-old.jpg

That one also drove autonomously but had no camera, no wifi and barely intelligence.

Here are some components for the new one. A camera (and a few broken ones), a raspberry pi zero 2 w, and 3 echo-locaters (ultrasonic). Oh and a compas: used to verify if the vehicle completely rotated (when that is required).

Components.jpg

Some power circuitry. Visible is a solarcell-lipo/lion-charger: I only use the li-ion-charger stuff of it. Out of it comes a voltage between somewhere 3 and 6V so I added something that makes a nice 5V of it.

Power.jpg

A nice motorhead, ehr, motor-hat by adafruit to control them weels:

Motorhead.jpg


For videostreaming I'll use Constatus ([1]).

The driving software is most likely in python.

Most components were bought from either China or from vngsystems in Gouda ([2]).

Test1.jpg

^ It might all fit and even work!

Note that I decided to use a standard battery pack for it. The motor-hat breaks down at 3A which is also the max of the pack.

What is left is a compass and lots of hot-glue. Software is also almost finished. Oh and I've added a powerbutton that power-downs safely the rpi when the button is a pressed for a bit.

Progress1.jpg

^ tiewraps and glue!