3D-Printer 1

NURDspace Project
Participants	Id
Skills
Status
Niche
Purpose
Tool
Location
Cost
Tool category

{{{Name}}}Property "Tool Name" (as page type) with input value "{{{Name}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:{{{Tool}}} | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:{{{Tool}}} | [[Tool Cost::{{{Cost}}} | }}

ID's 3D printer, the first child in progress

Well, I started this project with the idea to see how far i would get. I wanted to make the printer as cheap as possible, but my patience was less and i got lost from that focus. Anyway, the focus branch went another way and went more to some sort of 3D printing toy.

On the starting buZz had already printed some parts, but they were in all colors. With the idea to keep the prise low at that moment i accepted the challenge. For starter i needed some threaded rods which i bought at a local GAMMA DIY around the corner. With the help of a hacksaw i cutted the rod into the correct pieces.

Two holidays and a course i continued the project and ordered some of the stuff i needed (actually the0 did the ordering, thanks dude!) like motors, RAMPS, vertical bearings etc. Other parts i got thanks to profzon like the bearings, M8/M3 parts and rails.

Item	Quantity	Price
1 meter (not stainless steel) Threaded rod	6	€8.51
Printed parts	1	?
M8 nuts	?	?
M8 washers	?	?
M8 Bearings	2	?
Total		€8.51