| Nurd Plotter | |
|---|---|
 | |
| Participants | Melan |
| Skills | |
| Status | Active |
| Niche | Artsy stuff |
| Purpose | Tool |
| Tool | No |
| Location | |
| Cost | |
| Tool category | Fabrication |
Nurd Plotter Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:No | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:No | [[Tool Cost::{{{Cost}}} | }}
To teach myself more about electronics, as well as to finally step into the world of stepper-motors I would like to try to make a plotter. Since I don't know enough yet to completely design one from scratch, it will be build after Ben's PlottyBot as he did an excellent write-up on how he did his. It also has limiter-switches for homing and a servo that can move the pencil up and down, as well as an adjustable pen holder.
Right now this project is still in an "can I?" and "sourcing parts" state.
Parts
Note: I'm not including the raspberry pi zero in the part list because I still have one laying around.
| Item | Units | State | Link | Price | Remarks |
|---|---|---|---|---|---|
| 12V power supply | 1 | - | - | 0 | Sourcing this part isn't an issue. 2~3A seems to be enough. |
| 5v regulator | 1 | - | - | 0 | Should have a couple laying around |
| SG90 Servo | 1 | - | - | 0 | Can probably source from somewhere |
| 8mm x 450mm Linear rod | 2 | - | - | ? | Have to figure out where to buy, or maybe the space has two left. |
| 3mm x 100mm Linear rod | 2 | - | - | ? | Have to figure out where to buy, or maybe the space has two left. |
| LM8UU linear bearings | 8 | - | - | - | - |
| 2 Meter GT2 Timing Belt | 1 | - | - | - | - |
| 4mmx13mmx5mm ball bearings | 10 | - | - | - | - |
| 40mm cooling fan | 2 | - | - | - | Not sure if these are really needed. |
| Nema 17 Bipolar 40mm 64oz.in(45Ncm) 2A stepper | 2 | - | - | - | Assuming we can also go with one that is a slightly lower ampere |
| A3967 EasyDriver | 2 | - | - | - | We could probably also go with different drivers, if they fit. |
| Heatsinks | 2 | - | https://www.aliexpress.com/item/32817339178.html | € 1,66 | Comes in a 4 pack |
| Rubber Feet | 14 | - | - | - | Can probably buy them at the Action |
| M4 flat washers inside: 4.3m, item: 9m thickness: 0.8m | 50 | - | - | - | |
| M4 x 0.7mm 304 lock nuts | 50 | - | - | - | |
| M4x10mm thumb screws | 15 | - | - | - |
Probably is incomplete and or need more parts to be bought.