Pokons to do list

From NURDspace

Jump to: navigation, search
Pokons printer to do list
NoPicture.png
Participants
Skills
Status Planning
Niche Documentation
Purpose Infra
Tool Yes
Location everywhere where there is a printer
Cost dont know dont care
Tool category Electronics

Pokons printer to do list

"File:{{{Picture}}}" cannot be used as a page name in this wiki.

{{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}

Anet a8 stock

  • Resolder wires from the board to the mosfet (done)
  • PID tune so it wont overshoot about 50 degrees
  • check filament gear because of grinding (cleaned the fucker up)
  • Level the bed once again (done)

Malyan m200 Modded

  • write the marlin config
  • level the bed
  • PID tune
  • get a glass bed and relevel again

Super metal space printer (aka anet but with extrusions)

  • wire the electronics
  • get a mosfet for the bed
  • PID tune
  • Level the bed
  • testprint
  • make a cura profile
  • hook it up to octoprint
  • make a manual so that every nurd can use it

Envisiontec printer

  • poke envisiontec again
  • give buzz the backup finally so he can get the software hacked (ITS ON THE MACHINE ITSELF ON THE DESKTOP)
  • poke around in the community for an opensource alternative
 
Our site is hosted by Site4U
Site4U
Part of our connectivity is made available by BIT
To BIT's joboffers