No edit summary |
m (→Anet a8 stock) |
||
| Line 11: | Line 11: | ||
== Anet a8 stock == | == Anet a8 stock == | ||
* Resolder wires from the board to the mosfet | * Resolder wires from the board to the mosfet (done) | ||
* PID tune so it wont overshoot about 50 degrees | * PID tune so it wont overshoot about 50 degrees | ||
* check filament gear because of grinding | * check filament gear because of grinding (cleaned the fucker up) | ||
* Level the bed once again | * Level the bed once again (done) | ||
== Malyan m200 Modded == | == Malyan m200 Modded == | ||
Revision as of 20:04, 17 August 2018
| Pokons printer to do list | |
|---|---|
 | |
| Participants | |
| Skills | |
| Status | Planning |
| Niche | Documentation |
| Purpose | Infra |
| Tool | Yes |
| Location | everywhere where there is a printer |
| Cost | dont know dont care |
| Tool category | Electronics |
Pokons printer to do list Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}
Anet a8 stock
- Resolder wires from the board to the mosfet (done)
- PID tune so it wont overshoot about 50 degrees
- check filament gear because of grinding (cleaned the fucker up)
- Level the bed once again (done)
Malyan m200 Modded
- write the marlin config
- level the bed
- PID tune
- get a glass bed and relevel again
Super metal space printer (aka anet but with extrusions)
- wire the electronics
- get a mosfet for the bed
- PID tune
- Level the bed
- testprint
- make a cura profile
- hook it up to octoprint
- make a manual so that every nurd can use it
Envisiontec printer
- poke envisiontec again
- give buzz the backup finally so he can get the software hacked
- poke around in the community for an opensource alternative