Pokons to do list

Pokons printer to do list
Participants
Skills
Status	Planning
Niche	Documentation
Purpose	Infra
Tool	Yes
Location	everywhere where there is a printer
Cost	dont know dont care
Tool category	Electronics

Pokons printer to do list Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}

Anet a8 stock

• Resolder wires from the board to the mosfet (done)
• PID tune so it wont overshoot about 50 degrees
• check filament gear because of grinding (cleaned the fucker up)
• Level the bed once again (done)

Malyan m200 Modded

• write the marlin config
• level the bed
• PID tune
• get a glass bed and relevel again

Super metal space printer (aka anet but with extrusions)

• wire the electronics
• get a mosfet for the bed
• PID tune
• Level the bed
• testprint
• make a cura profile
• hook it up to octoprint
• make a manual so that every nurd can use it

Envisiontec printer

• poke envisiontec again
• give buzz the backup finally so he can get the software hacked (ITS ON THE MACHINE ITSELF ON THE DESKTOP)
• poke around in the community for an opensource alternative