| Pokons printer to do list | |
|---|---|
 | |
| Participants | |
| Skills | |
| Status | Planning |
| Niche | Documentation |
| Purpose | Infra |
| Tool | Yes |
| Location | everywhere where there is a printer |
| Cost | dont know dont care |
| Tool category | Electronics |
Pokons printer to do list Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}
Anet a8 stock
- Resolder wires from the board to the mosfet
- PID tune so it wont overshoot about 50 degrees
- check filament gear because of grinding
- Level the bed once again
Malyan m200 Modded
- write the marlin config
- level the bed
- PID tune
- get a glass bed and relevel again
Super metal space printer (aka anet but with extrusions)
- wire the electronics
- get a mosfet for the bed
- PID tune
- Level the bed
- testprint
- make a cura profile
- hook it up to octoprint
- make a manual so that every nurd can use it
Envisiontec printer
- poke envisiontec again
- give buzz the backup finally so he can get the software hacked
- poke around in the community for an opensource alternative