| Pokons printer to do list | |
|---|---|
 | |
| Participants | |
| Skills | |
| Status | Planning |
| Niche | Documentation |
| Purpose | Infra |
| Tool | Yes |
| Location | everywhere where there is a printer |
| Cost | dont know dont care |
| Tool category | Electronics |
Pokons printer to do list Property "Tool Image" (as page type) with input value "File:{{{Picture}}}" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process. {{{Picture}}} {{#if:Yes | [[Tool Owner::{{{ProjectParticipants}}} | }} {{#if:Yes | [[Tool Cost::dont know dont care | }}
Anet a8 stock -Resolder wires from the board to the mosfet -PID tune so it wont overshoot about 50 degrees -check filament gear because of grinding -Level the bed once again
Malyan m200 Modded -write the marlin config -level the bed -PID tune -get a glass bed and relevel again
Super metal space printer (aka anet but with extrusions) -wire the electronics -get a mosfet for the bed -PID tune -Level the bed -testprint -make a cura profile -hook it up to octoprint -make a manual so that every nurd can use it
Envisiontec printer -poke envisiontec again -poke around in the community for an opensource alternative